SE603 Ultrasonic Energy Meter and How To Install

SE603 Separate Ultrasonic Energy Meter
Velocity Rate: 0.328ft/s ~ ±16ft/s (0.1m/s ~ ±5m/s)
Accuracy: ±2.0%
Pipe Size: DN10 ~ DN100
Liquid: Regular water, sea water, cooling/hot water, alcohol...
Pipe Material: PVC, stainless steel, carbon steel, copper...

How To Install & Use:
Parameter Reference
1. Pipe Size: DN50
2. Liquid: water
3. Pipe Material: PVC

Steps:
1. Install top bracket and bottom bracket in vertical direction of pipeline
2. Tighten the four screws on the bracket
3. Peel off the sticker on the transducers
4. Fix the transducer base with transducer cable in the groove of the bracket and tighten the two screws
5. Usea syringe to inject thermal grease onto the probe at the bottom of the temperature sensor to enchance the signal
6. Use pipe strap to fix the temperature sensor at the inlet water
7. Adopt the same method to fix another temperature sensor at the outlet water
8. Connect the temperature sensor cable to the right port of the bottom of transmitter
9. Connect the upstream and downstream cable of transducers to the left port of the bottom of transmitter
10. Connect the power supply cable to the top port of transmitter
11. Hang the main unit on the hook through the small hole on the top
12. Turn on the power supply and power on immediately
13. Set related parameter: parameters refer to before the video
14. Open the pump and the flow begins to change until the value begins to stabilize
15. Close the pump. The flow value starts to become smaller and gradually becomes "0.00"